SHAKER DOORS ..catalog page 4

Shaker-1/4
Recessed 1/4" plywood panel.
Min. door width - 6"
Min. drw. height-7 1/8"
Sshaker
Solid lumber recessed  panel.
Min. door width - 6"
Min. drw. height-7 1/8"
Gshaker
Solid lumber recessed 
panel raise
#14 english grooves)
Drawer front panel
grooves and grain run
 vertically like the doors
Min. door width - 6"
Min. drw. height-7 1/8"
 
Shaker-1/4
with applied
moulding

Recessed 1/4" plywood panel.
Min. door width - 6"
Min. drw. height-7 1/8"
Rshaker
Solid lumber raised panel #26 (as shown)
Min. door width - 6"
Min. drw. height-7 1/8"
Gshaker
Solid lumber recessed 
panel raise
#15 ("V" grooves)
Drawer front panel grooves
and grain run vertically
like the doors
Min. door width - 6"
Min. drw. height-7 1/8"
All of our Shaker doors are produced with 65 mm rails and stiles as standard.  A wider width can be accommodated at an up charge.  If a size less than the minimum size noted here is ordered, then door stiles or drawer front rails may be reduced in width as necessary to produce this required size.  Frame only doors for glass are available, with or with out mullions.  (Note- frames are NOT grooved on the backside to accept rubber retainer)
 
Your choice of edge profiles
Lip #SH
Lip #11
"V" grooves at the joint of frame

and maybe something extra...

Raised plugs
in the door corners:

Home | Flat Panel Doors | Raised Panel Doors | Shaker Doors | Panel Profiles | Mitered Doors |

Additional Doors | Accent Doors | Accessories | Mullions | Mouldings and Trim | Order Forms